![siemens simatic plc sim ping siemens simatic plc sim ping](https://forum.visualcomponents.com/uploads/default/original/2X/2/2ce4425b168cbb867e520d83ebd38c80517469c0.jpeg)
Set Pg/Pc interface on TCP/IP and check that plcSim is using TCP/IP too: In my project this is the configuration of ethernet card: Siemens PLC and SIMATIC STEP 7 / TIA Portal Application note, Siemens PLC and SIMATIC STEP 7 / TIA portal of 43 Table of Contents Prerequisite for this guide 3 System overview 4 1. Now the PC that is running Step 7 and PLCSim is the PLC, this means that PC and ethernet card must have the same IP Address and if you are communicating with another PC you have to set also the router address. So every device that will connect to the PLC Sim Simulation (like a HMI Panel) has to use also that logical Access point to get access to the simulated IP. Now that your computer is connected to the same network as the PLC and the new program is saved in the correct location, launch the SIMATIC Automation Tool. Let’s create a new project, add a s7 300-2DP (standard configuration) and an ethernet card CP-343-1. you cannot ping your PLCSim (no Advanced -) ) because the simulated IP Adress works only 'inside' the Logical Accesspoint that you use in the PGPC Settings. C:ProgramDataSiemensSIMATIC Automation ToolPrograms In our situation, DMC simply emailed the S7S file to our client and they saved it in the proper location on their computer. With NetToPLCSim you are able to connect your SCADA/HMI-systems via S7-communication to PLCSim over TCP/IP, and read/write data areas from your simulated PLC.Ģ- Ethernet cable plugged in (some peoples says this is needed)ģ- Port 102 Opened (so exception in your firewall and shutdown s7oiehsx service (command line from start -> run : net stop s7oiehsx)
Siemens simatic plc sim ping how to#
This is a tutorial on how to connecto to NetToPlcSim. The official site to download the program is here: